Gaming and Synthetics on Processor Graphics

The Haswell Pentium and Celeron ranges are filled with GT1 solutions, referred to as simply 'HD (Haswell)'. The same is true for Sandy Bridge and Ivy Bridge, although with Haswell the i3 CPU range upgraded to HD 4400 or HD 4600 - a significant leap in performance.  As the graphics power is low for full 3D titles, and as such we test on lower frequencies, we might see the CPU power matter more here than with our Devil's Canyon review.

F1 2013

F1 2013 (Processor Graphics), Average FPS

F1 2013 (Processor Graphics), Minimum FPS

Bioshock Infinite

Bioshock Infinite (Processor Graphics), Average FPS

Bioshock Infinite (Processor Graphics), Minimum FPS

Tomb Raider

Tomb Raider (Processor Graphics), Average FPS

Tomb Raider (Processor Graphics), Minimum FPS

Sleeping Dogs

Sleeping Dogs (Processor Graphics), Average FPS

Sleeping Dogs (Processor Graphics), Minimum FPS

Company of Heroes 2

Company of Heroes 2 (Processor Graphics), Average FPS

Company of Heroes 2 (Processor Graphics), Minimum FPS

CompuBench 1.5

CompuBench is a new addition to our CPU benchmark suite, and as such we have only tested it on the following processors.  The software uses OpenCL commands to process parallel information for a range of tests, and we use the flow management and particle simulation benchmarks here.

CompuBench 1.5 Optical Flow (Processor Graphics)

CompuBench 1.5 64k Particles (Processor Graphics)

3DMark Fire Strike

3DMark FireStrike (Processor Graphics)

The increase in speed due to overclocking only has one effect on gaming using the internal graphics - a slight advantage to minimum frame rates.  Unfortunately the IGP is crippled too much to see any gain in performance for average frame rates and AMD APUs at similar power outputs have up to a 2x advantage.

CPU Benchmarks Discrete GPU Gaming
Comments Locked

96 Comments

View All Comments

  • jqwest303 - Wednesday, August 13, 2014 - link

    I got G3258 and MSI B85M gaming motherboard at Newegg for $99 free shipping, Then got coolermaster t4 for $15 after rebate, updated bios,got chip oc'd to 4.9 at 1.4 but temps got to 80-82 under full load with prime95 so I lowered to 1.23 volts and 4.6 ghz temps under load stable at 65 and 30 at idle...not bad for a $99 motherboard cpu combo
  • tandlion13 - Wednesday, August 20, 2014 - link

    Good to know that an overclocked Pentium can match an i3 in most tasks. I'm going to build this one and that will be a nice new PC for my mom :) Thanks for a good review.
  • LatexJimmy - Wednesday, August 27, 2014 - link

    I got this in a combo cpu+mobo for $80 and an evo 212 cooler for $25 which puts me below the cost of the i3 (currently around $130) and it runs very well. Alot of the comments seem to be "Well if you just spent 40,80,100 dollars more you'd be better off. But why stop there? Don't be cheap! Spend a couple grand that you have lying around and laugh at the poor budget gamers with families and bills.
  • deV14nt - Saturday, October 25, 2014 - link

    I'm late to the party but I don't care. I got this as a combo with an ECS Z97 PK for $100. Makes sense to me, because I was upgrading a Core 2 Duo E6600 build and I didn't want to spend double on DDR2 when I could just get a new board with just a small investment that could later get anything up to a current i7 later on. $100 + $70 for a single 8GB stick of RAM so I can add another one of those later, with 32GB total possible. That's a good investment in a modern platform. Paired it with a 750 Ti for another hundred. Probably could have gone higher on that, but the deals just weren't there.
  • gruffi - Friday, November 28, 2014 - link

    The comparison table is completely flawed. If you compare A vs B and get +X% it doesn't mean you get -X% if you compare B vs A. You actually get 100/(1+X/100)-100 percent for B vs A.

    For example, with 3DPM-ST (-25%) and 3DPM-MT (+33%) you get an average of +4% in favor of the i3. Which is not correct. -25% for the i3 means +33% for the Pentium in 3DPM-ST. Which basically nullifies the advantage of the i3 in 3DPM-MT. So, an average of 0% would be correct in these two tests, not 4%.

    I don't know why the author can make such simple mistakes. This is not professional.
  • Abdou - Friday, June 2, 2017 - link

    Please help, I have h97-d3h and Intel G3258, but motherboard can't overclocked it above 3.8 GHz,
    So, i needs to know how overclocked it above 3.8, volt and power required "watt"
    Thanks

Log in

Don't have an account? Sign up now